Soluciones hechas para el negocio de la publicidad.
Unit cost
MXN 489.54
/set
Wholesale discounts
Quantity
Discount
Price per unit
1-2
0%
MXN 489.54
3-4
2%
MXN 480.17
5-6
4%
MXN 470.80
7+
6%
MXN 461.46
Total Cost
MXN 489.54
Amount
/set
1
Remarks:
• You’d better use the bender with proper strength; otherwise it will cause heat loss and heat uneven.
• If the arc length is greater than heating plate breadth, you can use the arc bender to heat 1-3 times continuously and arrange in a row. The arc length be bent is within 150mm.
• With short preheat time; restart the bender won't waste too much time. If you do not use it more than 5 minutes, please shut off the power switch to save electricity.
• Please do not put the heating plate onto the power cable.
• Kindly remind you that heating transparent acrylic could leave tiny marks on the material, which is not clear on the acrylic of other colors. Please notice it when you place an order.
• 1pc PTFE Coated Fiberglass Adhesive Tape will be gift for you when you buy A type angle bending tools.
How to use the High Temperature PTFE Coated Fiberglass Adhesive Tape?
Place cut the adhesive tape into 3mm width, and then stick them on both sides of angle bender respectively. The PTFE Coated Fiberglass adhesive tape can be used many times.
You can use the PTFE Coated Fiberglass Adhesive Tape when you want heat PVC board.
 |
 |
| Heating plate of our Acrylic Bender | Heating plate of COPYCAT Acrylic Bender |
 |
 |
| Temperature Control PCB part of our Acrylic Bender | Temperature Control PCB part of COPYCAT Acrylic Bender |
 |
 |
| Power Switch part of our Acrylic Bender | Power Switch part of COPYCAT Acrylic Bender |
 |
 |
| Power Plug of our Acrylic Bender | Power Plug of COPYCAT Acrylic Bender |
| PERFORMANCE COMPARISON | |
 |
 |
| Our Acrylic Bender | COPYCAT Acrylic Bender |
 |
 |
| About heating insulation film, the reason our acrylic bender do not put heat insulation film is the operator do not need to use finger to clamp this area to bend acrylic sheet. If you choose our original acrylic bender, you just need to handheld to operate as bellow. As the copycat cannot hold the acrylic sheet seamlessly so that will need your finger to help to bend it like below picture, so they have to put insulation film or their acrylic bender cannot hold and bend acrylic bender fully. |
|
 |
 |
| Our Acrylic Bender | COPYCAT Acrylic Bender |
| About Vertical guide in copycat products, as we design acrylic bender its head are all flat, so it will have an vertical angle against desk when operator use it, so this vertical guide is totally useless. Our Acrylic bender head are all designed to be flat, that will have vertical angle when operator use it against desk | |
 |
 |
